Gas/Smoke Detector
Automation Components (ACI) | Part Number: ESENSER
The ESENSE Series is based on a single beam non-dispersive infrared technology and is a cost-optimized solution for the climate control of buildings and other processes. Includes a 0-10 VDC, 2-10 VDC or 4-20 mA Output
Ships in 4-6 weeks
ABC software eliminates the need for manual calibration. The ESENSE Series measures the CO2 concentration in the ambient air up to 2,000 ppm and converts the data into an analog output.

ESENSE-R Technical Data

Supply Voltage
24 VAC/VDC +/- 20%; 50/60Hz (Half-wave rectified)

Power Consumption
more than 1W

Electrical Connections
0.00232 in (1.5 mm) screw terminals

Operating Temperature
32F to 122F (0C to 50C)

Operating RH
0 – 95% RH Non-condensing

Warm-Up Time
1 minutes (@ full specs 15 minutes)

+/- 30 ppm +/- 3% of reading

+/- 20 ppm +/- 1% of measured value

Annual Zero Drift
+/- 0.3% of measurement range

Operating Pressure
+1.6% per 0.145 psi (1 kPa) deviation from normal pressure

Sensing Method
Single beam Non-dispersive Infrared (NDIR)

Sensor Life
More than 15

Response Time
more than 10 seconds @ 30 cc/min flow rate, more than 3 minutes diffusion time

Operating Environment
Residential, Commercial spaces

Sensing Range
0 to 2000 ppm

Extended CO2 Ranges
Up to 10,000 ppm (factory set or SADK Kit required)

Extended Range Accuracy
+/- 30 ppm and +/- 5% of reading

Coverage Area
7500 sq. ft. maximum

Mounting Height
4-6’ o the floor

Sense air ABC algorithm (Automatic Baseline Correction)

Standard: Out 1: 0-10V for 0 to 2000 ppm

ESENSE-R: -40 to 158F (-40 to 70C)

ABS, Flammability Rating UL94V-0

Room Dimensions
(H) 5.12" (130 mm) x (W) 3.35" (85.1 mm) x (D) 1.18" (30 mm)